Adjusting The Flow Baffle - Toro 74266 Operator's Manual

Note: The two middle rollers will not have a spacer
(Figure 21).
4. Select a hole so the anti-scalp roller is positioned to the
nearest corresponding height-of-cut desired.
5. Install the flange nut bushing, spacer, and bolt. Torque
to 40-45 ft-lb (54-61 N-m) (Figure 20 , Figure 21 and
Figure 22 ).
6. Repeat this adjustment on the other anti-scalp rollers.
Figure 20
1. Anti-scalp roller
2. Spacer
3. Bushing
Figure 21
1. Anti-scalp roller
2. Bushing
4. Flange Nut
5. Bolt
3. Flange Nut
4. Bolt
1. Anti-scalp roller
2. Spacer
3. Bushing

Adjusting the Flow Baffle

The mower discharge flow can be adjusted for different types
of mowing conditions. Position the cam locks and baffle to
give the best quality of cut.
1. Disengage the PTO, move the motion control levers to
the neutral locked position and set the parking brake.
2. Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3. To adjust the cam locks, swing the lever up to loosen
the cam lock (Figure 23).
4. Adjust the baffle and cam locks in the slots to the
desired discharge flow.
5. Swing the lever back over to tighten the baffle and cam
locks (Figure 23).
6. If the cams do not lock the baffle into place or it is too
tight, loosen the lever and then rotate the cam lock.
Adjust the cam lock until the desired locking pressure
is achieved.
1. Cam lock
2. Lever
24
Figure 22
4. Flange Nut
5. Bolt
Figure 23
3. Rotate cam to increase or
decrease locking pressure
4. Slot