System Messages; Error Messages - Dell PowerEdge T20 Owner's Manual

System Messages

Error Messages

Error Message Description
Address mark not The BIOS found a faulty disk sector or could not find a particular disk sector.
found
Alert! Previous The system failed to complete the boot routine three consecutive times for the
attempts at same error. Contact Dell and report the checkpoint code (nnnn) to the support
booting this technician.
system have failed
at checkpoint
[nnnn]. For help in
resolving this
problem, please
note this
checkpoint and
contact Dell
Technical Support.
Alert! Security The MFG_MODE jumper has been set and AMT Management features are disabled
override Jumper is until it is removed.
installed.
Attachment failed The floppy or hard-drive controller cannot send data to the associated drive.
to respond
Bad command or Ensure that you have spelled the command correctly, put spaces in the proper
file name place, and used the correct pathname.
Bad error- The floppy or hard-drive controller detected an uncorrectable read error.
correction code
(ECC) on disk read
Controller has The hard drive or the associated controller is defective.
failed
Data error The floppy or hard drive cannot read the data. For the Windows operating system,
run the chkdsk utility to check the file structure of the floppy or hard drive. For any
other operating system, run the appropriate corresponding utility.
Decreasing One or more memory modules may be faulty or improperly seated. Re-install the
available memory memory modules and, if necessary, replace them.
Diskette drive 0 A cable may be loose or the system configuration information may not match the
seek failure hardware configuration.
8
79