Installing The Power Switch - Dell PowerEdge T20 Owner's Manual

Figure 10. Removing and Installing the Power Switch
1. power switch

Installing The Power Switch

CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1. Turn off the system, including any attached peripherals, and disconnect the system from the
electrical outlet and peripherals.
2. Lay the system on its side, on a flat and stable surface.
3. Open the system.
4. Slide the power switch through the slot on the front of the system and secure it to the system.
5. Route the power-switch cable through the chassis clip.
6. Connect the power-switch cable to the power-switch connector on the system board.
7. Install the following components:
a. optical drive
For information on installing the optical drive, see
b. bezel
8. Close the system.
9. Place the system upright on a flat, stable surface.
10. Reconnect the system to its electrical outlet and turn the system on, including any attached
peripherals.
32
2. screw
Installing The Optical Drive.