Memory Beep Code; Troubleshooting System Startup Failure; Troubleshooting External Connections; Troubleshooting The Video Subsystem - Dell PowerEdge T20 Owner's Manual

Amber LED Description
State
2,7 memory modules are detected, but a memory failure
3,1 possible peripheral card or system board failure
3,2 possible USB failure
3,3 no memory modules are detected
3,4 possible system board error
3,5 memory modules are detected, but a memory configuration or compatibility error
3,6 possible system board resource and/or hardware failure
3,7 some other failure with messages on screen

Memory Beep Code

The system emits a series of beeps during startup if it detects no memory. The beep code pattern emitted
is 1-3-2 (1 beep, then 3 beeps, then 2 beeps). The delay between each beep is 300 ms, the delay between
each set of beeps is 3 secs, and the beep sound lasts 300 ms. Reseating the memory modules may fix the
memory errors. After emitting beeps, the BIOS will detect if the user presses the power button and will
execute the normal shutdown process and power the system off.

Troubleshooting System Startup Failure

If you boot the system to the BIOS boot mode after installing an operating system from the UEFI boot
mode, the system hangs. The reverse is also true. You must boot to the same boot mode in which you
installed the operating system.
For all other startup issues, note the system messages that appear on the screen.

Troubleshooting External Connections

Ensure that all external cables are securely attached to the external connectors on your system before
troubleshooting any external devices.

Troubleshooting The Video Subsystem

1. Check the system and power connections to the monitor.
2. Check the video interface cabling from the system to the monitor.
3. Run the appropriate diagnostic test.
If the tests run successfully, the problem is not related to video hardware.
If the tests fail, see Getting Help.
63