Table of Contents
Advertisement
Fuse
Service Interval/Specification
The electrical system is protected by fuses. It requires
no maintenance: however, if a fuse blows check
component/circuit for malfunction or short.
Fuse:
Main F1–20 amp, blade-type
Alternator F2–20 amp, blade-type
1.
Raise the seat to gain access to fuse holder
(Fig. 52).
2.
To replace fuses pull out on the fuse to remove it
(Fig. 52).
2
Figure 52
1. Main-20 amp
1
m–3653
2. Alternator-20 amp
Battery
Check the electrolyte level in the battery every 25
hours. Always keep the battery clean and fully
charged. Use a paper towel to clean the battery case.
If the battery terminals are corroded, clean them with
a solution of four parts water and one part baking
soda. Apply a light coating of grease to the battery
terminals to prevent corrosion.
Voltage: 12 v
Checking Electrolyte Level
1.
Open covers to see into the cells. The electrolyte
must be up to the lower part of the tube
(Fig. 53). Do not allow the electrolyte to get
below the plates. (Fig. 53).
2.
If the electrolyte is low, add the required amount
of distilled water; refer to Adding Water to the
Battery.
2
Figure 53
1. Filler caps
2. Lower part of tube
Maintenance
1
3
1262
3. Plates
57
Hide quick links:
Advertisement
Table of Contents
