Greasing And Lubrication - Toro 74175 Operator's Manual

Greasing and Lubrication

Lubricate the machine when shown on the CHECK
SERVICE REFERENCE AID decal (Fig. 33). Grease
more frequently when operating conditions are
extremely dusty or sandy.
Grease with No. 2 general purpose lithium base or
molybdenum base grease.
How to Grease
1. Disengage the power take off (PTO) and turn the
ignition key to "OFF" to stop the engine.
Remove the key.
2. Clean the grease fittings with a rag. Make sure to
scrape any paint off the front of the fitting(s).
3. Connect a grease gun to the fitting. Pump grease
into the fittings until grease begins to ooze out of
the bearings.
4. Wipe up any excess grease.
Where to Add Grease
Lubricate the grease fittings as shown on the CHECK
SERVICE REFERENCE AID decal (Fig. 33).
Figure 33
Grease Front Castor Pivots
Lubricate the front castor pivots once a year.
1. Remove hex plug and cap. Thread a grease zerk
into hole.
2. Pump grease into zerk until it oozes out around
top beraring.
3. Remove grease zerk in hole. Reinstall hex plug
and cap.
Where to Add Light Oil or Spray
Lubrication
Lubricate the machine in the following areas with
spray type lubricant or light oil.
Seat switch actuator.
Brake handle pivot.
Brake rod bushings.
Motion control bronze bushings.
Maintenance
45