Greasing The Bearings; Check The Leveling Of Mower Deck; Check Side Discharge Chute; Check Engine Oil Level - Toro 74175 Operator's Manual

Assembly

Greasing the Bearings

Make sure cutting unit spindles are full of grease
before engine is first started.
Grease with No. 2 general purpose lithium base or
molybdenum base grease.
1. Grease the fittings on the three spindle bearings.
Grease until it comes out lower seals (Fig. 9).
Figure 9
1. Spindles
Check the Leveling of Mower
Deck
Check the level of the deck before machine is first put
into use.
Refer to Mower Leveling and Compression Spring
Adjustment in the Maintenance section on page 50.

Check Side Discharge Chute

Remove plastic tie holding side discharge chute up
and lower into place.
22

Check Engine Oil Level

Before you start the engine and use the machine,
check the oil level in the engine crankcase; refer to
Checking Oil Level, page 41.
1