General Specifications; Setup; Loose Parts - Toro 30822 Operator's Manual

General Specifications

Chamber Construction
Blade
Tip Speed
Blade Plane
(factory pre-set)
Height of Cut
Deck Drive
Spindles
Discharge
Mulching Baffle (Optional) Pre-drilled mounting holes provided in decks
Front Rollers
Rear Roller
Anti-Scalp Cup
Roller Scraper
Suspension
Weight

Setup

Note: Determine the left and right sides of the machine from the normal operating position.

Loose Parts

Note: Use this chart as a checklist to ensure that all parts have been received. Without these parts, total setup cannot be
completed.
Description
Decal
Parts Catalog
Operator's Manual
Registration Card
Welded 10 GA (.1345 in.) and 12 GA (.1036 in.) steel. Spindle support is 3/16 in.
high-strength steel and 10 GA exterior channels, withstands multiple blade impact
tests. Deck frame is welded 1-1/2 in. square tubing and 7 GA (.1793 in.) side
supports, protects chamber, withstands collisions.
Heat treated steel
16,300 ft./min. nominal
Height of Cut 2.00 (5.08 cm)
Right or left side 2.15 (5.46 cm)
Side to side within .03 in. (.08 cm) of each other
Blade rake approximately 5/16 in. (.79 cm)
3/4–4 in. (1.91–10.16 cm) in 1/4 in. (.64 cm) increments
Hydraulic, closed loop, integrated relief. High efficiency press. balanced gear type
pump. High efficiency press. Balanced gear type motor. Recommended oil is Mobil
DTE 15M (Mobil EAL biodegradable compatible).
1-1/4 in. (3.17 cm) shaft, greasable, tapered roller bearing, ductile iron housing
which withstands multiple impact tests.
Rear, even clipping distribution in wet or dry conditions
Two 5 in. (12.7 cm) diameter, ductile iron w/hollow core, sealed bearings, close
location to blade
One 3 in. (7.6 cm) diameter, steel, sealed bearings, exterior shaft seal, full length,
close location to blade
6 in. (15.2 cm) standard
Welded straight edge and 5/16 in. (.79 cm) diameter rod; located below centerline
for self cleaning
Non-steering carrier frame
190 lb. (86 kg)
Qty. Use
1 Apply to cutting deck for CE
1
1 Read before operating the machine.
1 Fill out and return to Toro.
4