Specifications; General Specifications; Optional Equipment - Toro Groundsmaster 200 Series Operator's Manual

Specifications

General Specifications

Width of Cut
Height of Cut
Blade Tip Speed
Cutter Housing
Cutting Unit Drive
Cutting Unit Blades
Castor Wheels
Cutting Unit Lift
Weight
Note: Specifications and design subject to change without notice.

Optional Equipment

Spindle Assembly
Blade and Belt Kit
Castor Wheel
Castor Wheel Set (set of 4 wheels)
62 in. (157 cm)
Adjustable from 1-1/2 to 4-1/2 in. (38 to 114 mm) in 1/2 inch increments
15,480 ft./min. @ 3250 engine RPM
4 in. (102 mm) deep housing is made of 12 gauge steel and reinforced with 10
gauge channel and plates.
Isolation mounted gear box on cutting unit is drive by PTO shaft. Power is
transmitted to the blades by one hex "AA" section belt. Spindle shafts are 1 in.
(25 mm) diameter and supported by 2 greaseable, tapered roller bearings.
Three 21-3/4 in. (55.2 cm) long and 1/4 in. (6 mm) thick heat-treated, steel
recycling blades
Front and rear castor wheels have 8 in. (203 mm) x 3-1/2 in. (89 mm) hard rubber
tires and roller bearings.
Independent lift arms and hydraulic weight transfer provide deck flotation.
340 lb. (154 kg)
Part No. 95-3081
Part No. 95-3073
Part No. 85-5760
Part No. 95-3076
7