Table of Contents
Advertisement
Specifications
Note: Specifications and design subject to change without
notice.
General Specifications
Chamber Construction
Blade
Tip Speed
Blade Plane
(factory pre-set)
Height of Cut
Deck Drive
Spindles
Discharge
Mulching Baffle (Optional) Pre-drilled mounting holes provided in decks
Front Rollers
Rear Roller
Anti-Scalp Cup
Suspension
Weight
Welded 7 GA (.1793 in.),10 GA (.1345 in.) and 12 GA (.1036 in.) steel. Spindle
support is 3/16 in. high-strength steel and 10 GA exterior channels, withstands
multiple blade impact tests. Deck frame is welded 1-1/2 in. square tubing and 7 GA
(.1793 in.) side supports, protects chamber, withstands collisions.
27" long, combo sail, heat treated steel
15,400 ft./min. nominal
Height of Cut
2.00 (5.08 cm)
Right or left side
2.15 (5.46 cm)
Side to side
within .09 in. (.23 cm) of each other
Blade rake
approximately 5/16 in. (.79 cm)
3/4–4 in. (1.91–10.16 cm) in 1/4 in. (.64 cm) increments
Hydraulic integrated relief. High efficiency gear type pump. High efficiency gear
type motor. Recommended oil is Mobil DTE 15M (Mobil EAL biodegradable
compatible).
1-1/4 in. (3.17 cm) shaft, greasable, tapered roller bearing, ductile iron housing
which withstands multiple impact tests.
Rear, even clipping distribution in wet or dry conditions
Two 5 in. (12.7 cm) diameter, ductile iron w/hollow core, sealed bearings, close
location to blade
One 3 in. (7.6 cm) diameter, steel, exterior shaft seal, full length, close location to
blade
6 in. (15.2 cm) standard
Non-steering carrier frame
195 lb. (88 kg)
4
Advertisement
Table of Contents
