Maintenance; Recommended Maintenance Schedule - Toro 30438 Operator's Manual

Maintenance

Note: Determine the left and right sides of the machine from the normal operating position.

Recommended Maintenance Schedule

Maintenance Service
Interval
Each Use
After first 8 Hours
8 Hours
25 Hours
40 Hours
50 Hours
100 Hours
200 Hours
250 Hours
400 Hours
At storage or 400 Hours
1
More often in dusty, dirty conditions.
Important
Refer to your engine operator's manual for additional maintenance procedures.
If you leave the key in the ignition switch, someone could accidently start the engine and
seriously injure you or other bystanders.
Remove the key from the ignition and disconnect the spark plug wire from the spark plug(s)
before you do any maintenance. Set the wire aside so that it does not accidentally contact the
spark plug.
Maintenance Procedure
Engine Oil—check level
Safety System—check
Brake—check
Engine—clean outside
Mower Housing—clean
Engine Oil—change
Mower Housing—clean
Caster Wheels—grease
Caster Pivot—grease
Cutting Blades—check
Foam Air Cleaner—clean
Tires—check pressure
PTO Belt Idler Arm—grease
Belts—check
Paper Air Cleaner—clean
1
Engine Oil—change
Spark Plug(s)—check
Electric Clutch—adjust
Engine—clean outside
Fuel Filter—replace
Engine Oil Filter—change (200 hours or every other oil change)
Paper Air Cleaner—replace
Transmission Couplings—grease
Wheel Bearings—grease
Chipped Surfaces—paint
Perform all maintenance procedures listed above before storage
Caution
26
1
1
1
1