Checking The Tire Pressure; Servicing The Fuse; Adjusting The Electric Clutch - Toro 30438 Operator's Manual

Mid–size mower proline gear 17 hp with 52in side discharge mower
Table of Contents

Advertisement

Figure 39

Checking the Tire Pressure

Service Interval/Specification
Maintain the air pressure in the front and rear tires as
specified. Check the pressure at the valve stem after every
40 operating hours or monthly, whichever occurs first
(Fig. 40). Check the tires when they are cold to get the most
accurate pressure reading.
Rear Tire Pressure: 12–14 psi (83–97 kPa)
Caster Tire Pressure: 25–30 psi (172–207 kPa)
Figure 40
1. Rear Tire
m–5196
1
2
m–6367
2. Caster tire
32

Servicing the Fuse

Service Interval/Specification
The electrical system is protected by a fuse. It requires no
maintenance. If the fuse blows check component or circuit
for malfunction or short. To replace fuse, pull out on the
fuse (Fig. 41) and push in new fuse.
Figure 41
1. Fuse, 10 amp blade type

Adjusting the Electric Clutch

The clutch is adjustable to ensure proper engagement and
proper braking. Check adjustment after every 100 hours of
operation.
1. To adjust the clutch, tighten or loosen the lock nuts on
the flange studs (Fig. 42).
2. Check adjustment by inserting a feeler gauge thru the
slots next to the studs (Fig. 42).
3. The proper disengaged clearance between the clutch
plates is 0.012–0.024 inch (0.30-0.60 mm). It will be
necessary to check this clearance at each of the three
slots to ensure the plates are parallel to each other.
1
m–7676

Advertisement

Table of Contents
loading

Table of Contents