Threading Right Cover Stitch Needle - JUKI MCS-1500 Instruction Manual

Threading 4 thread cover stitch
7
8
6
9
10
6
1
2
3
5
4
4
5
9
10
1009

2. Threading right cover stitch needle

(blue)
• Switch the machine off (Power switch to "0").
Place the spool on the spool holder pin as illustrated.
(1) Bring the thread up from the spool and lay it from the
back to the front into the guides.
(2, 3) Make an S-loop around thread guide bar.
(4) Thread the tension dial.
(5, 6) Thread the guides.
(7) Thread the take up.
(8) Thread the guide.
(9) Thread the needle clamp guide.
(10) Thread the right needle eye from front to back and
lay the thread over the presser foot to the left. Cut the
thread to about 7 cm (3").
(11) Check that the cover stitch presser foot is attached
for cover stitch sewing.
Note:
If the looper thread has to be re-threaded, cut the needle
threads above the needle eye and remove. Thread the
looper first and then the needles.
14