Installing The Seat; Installing The Roll Over Protection System - Toro Z Master 74141TE Setup Instructions

3. Remove the wheel nuts from both sides of the
vehicle and remove the right angle retaining plate.
Discard the screws and retaining plate.
4. Mount the wheels with the valve stem to the outside
and secure them with the wheel nuts previously
removed.
5. Torque the wheel nuts to 95 ft-lb (128 N-m).
6. Remove the jack-stands.
4
Installing the Roll Over
Protection System
Parts needed for this procedure:
1 Rollover Protection System Kit (ROPS)
Procedure
Install the Rollover Protection System Kit. Follow the
instructions included with the ROPS Kit.
Figure 3
Figure 4
5

Installing the Seat

Parts needed for this procedure:
1 Seat
1 Seat plate
2 Guard
8 Flange nuts (5/16 inch)
Procedure
1. Remove the 4 nuts holding the seat plate to the
machine. Discard these nuts, they are used for
shipping only.
2. Remove the plastic cable ties holding the guards to
the seat plate.
3. Secure the seat plate and guards to the seat with 4
flange nuts (5/16 inch).
3
g017994
Figure 5