Table of Contents
Advertisement
1
2
3
4
13
Checking the Machine for
Grease
Parts needed for this procedure:
Number 2 general purpose lithium base or
1 tube
molybdenum base grease. (Purchase separately.)
Procedure
Check the grease for the idler arm on the mower deck.
If needed, add grease until it comes out of the seals.
G008942
Figure 16
14
Checking the Side Discharge
Chute
No Parts Required
Procedure
If there are plastic ties holding the side discharge chute
up, remove them and lower the chute into place.
WARNING
An uncovered discharge opening could allow the
lawn mower to throw objects in the operator's or
bystander's direction and result in serious injury or
death. Also, contact with the blade could occur.
Never operate the lawn mower with the grass
deflector removed unless you install a cover plate, a
mulch plate, or a grass chute and catcher.
1. Make sure the L end of spring is installed behind
the deck edge before installing the bolt as shown in
Figure 18.
2. Place the J hook end of spring around grass deflector
(Figure 18).
Important: The grass deflector must be free to
rotate with downward tension. Lift the deflector
up to the full open position and ensure that it
rotates freely, without binding into the full down
position.
8
g017435
Figure 17
Advertisement
Table of Contents
