Table of Contents
Advertisement
4. Insert the dipstick into the oil-fill tube and screw it in
until it stops.
5. Remove the dipstick and read the oil level on the
dipstick
(Figure
6).
•
If the oil level is below the Add mark on the
dipstick, slowly add a small amount of oil to the
oil-fill tube, and then repeat steps
the oil level is at the Full mark on the dipstick.
•
If the oil level is above the Full mark on the
dipstick, drain the excess oil until the oil level is at
the Full mark on the dipstick. To drain the excess
oil, refer to
Changing the Engine Oil (page
Important: If the oil level in the crankcase is
too low or too high and you run the engine,
you may damage the engine.
6. Install the dipstick securely by hand.
4
Charging the Battery
(Electric-start model only)
No Parts Required
Procedure
Refer to
Charging the Battery (Electric-start model only)
(page
15).
5
Assembling the Grass Bag
No Parts Required
Procedure
1. Slip the grass bag over the frame as shown in
3
through
5
until
14).
1. Handle
2. Frame
2. Hook the bottom channel of the bag onto the bottom
Figure
7.
3. Hook the top and side channels of the bag onto the top
7
1
2
Figure 7
Note: Do not slip the bag over the handle
of the frame
(Figure
8).
Figure 8
and sides of the frame, respectively
g027543
3
3. Grass bag
(Figure
g027544
(Figure
8).
7).
Advertisement
Table of Contents
