Adjusting The Self-Propel Drive Cable (Self-Propel Model Only); Cleaning The Under The Machine - Toro 29730 Operator's Manual

Adjusting the Self-Propel Drive
Cable (Self-propel model only)
Whenever you install a new self-propel cable or if the
self-propel drive is out of adjustment, adjust the self-propel
drive cable.
1. Loosen the cable-support nut
1. 25 to 38 mm (1 to 1-1/2
inches)
2. Self-propel drive bar
3. Cable jacket
2. Hold the self-propel bail 25 to 38 mm (1 to 1-1/2
inches) from the handle
3. Pull down the cable jacket (toward the machine) until
there is no slack in the cable
4. Tighten the nut on the cable support.
5. Release the self-propel drive bar and ensure that the
cable is loose.
Note: The cable must be loose with the self-propel
drive bar in the released position; otherwise, the
machine may creep when you disengage the bar.
(Figure 30).
Figure 30
4. Cable-support nut
5. Cable support
(Figure 30).
(Figure 30).
Cleaning the Under the
Machine
Service Interval: After each use
WARNING
The machine may dislodge material from under the
machine.
• Wear eye protection.
• Stay in the operating position (behind the
handle).
• Do not allow bystanders in the area.
1. With the engine running on a flat paved surface, spray a
stream of water in front of the right rear wheel
31).
The water will splash into the path of the blade,
cleaning out the clippings.
2. When no more clippings come out, stop the water and
move the machine to a dry area.
3. Run the engine for a few minutes to dry the underside
of the machine to prevent it from rusting.
17
Figure 31
(Figure