Toro 30881 Operator's Manual page 34

•
Steering cylinder ball joints (2)
1. Top fitting on king pin
•
Tie-rod ball joints (2)
•
King-pin bushings (2)
the king pin should only be lubricated annually
(2 pumps).
•
Lift-arm bushings (1 per deck)
•
Lift-cylinder bushings (2 per deck)
(Figure 22)
Figure 22
(Figure 22)
(Figure 22). The top fitting on
(Figure 23)
Figure 23
(Figure 23)
•
Cutting unit spindle-shaft bearings (1 per cutting unit)
(Figure 24)
•
Cutting unit carrier-arm bushings (1 per cutting unit)
(Figure 24)
•
Rear-roller bearings (2 per cutting unit)
Important: Make sure that the grease groove in
each roller mount aligns with the grease hole in each
end of the roller shaft. To help align the groove and
hole, there is also an alignment mark on 1 end of the
roller shaft.
34
Figure 24
(Figure 25
Figure 25
)