Toro 30881 Operator's Manual page 18

InfoCenter Icon Description (cont'd.)
Stop the engine.
Engine
Key switch
Cutting units are lowering.
Cutting units are raising.
PIN passcode
Hydraulic oil temperature
CAN bus
InfoCenter
Bad or failed
Center
Right
Left
Bulb
Output of TEC controller or control
wire in harness
Over the allowed range
Under the allowed range
Out of range
/
Switch
Operator must release switch.
Operator should change to indicated
state.
Symbols are often
combined to form
sentences. Some
examples are shown
below
InfoCenter Icon Description (cont'd.)
18
Operator should put machine in
neutral.
Engine start is denied.
Engine shutdown
Engine coolant is too hot.
Hydraulic oil is too hot.
Sit down or set parking brake