Error Indicators - Omron HBF-400 Instruction Manual

ERROR DISPLAY

ERROR INDICATORS

CAUSE
Your toes and heels are
not positioned over the
electrodes correctly.
The measurement position was not
stable or your feet were not
placed correctly.
Feet are too dry.
The body fat percentage or BMI
values are outside the
measurement range.
The unit is not set up correctly.
You stepped onto the measurement
platform before 0.0 lb
was displayed.
The unit was moved before 0.0 lb
was displayed.
Movement during measurement
This unit can only be used by people
weighing less than 330 lbs.
M
ake sure you are barefoot and the
soles of your feet are clean and dry.
Make sure your feet are correctly
positioned on the measurement platform.
Read "How to Take a Measurement"
on page 14.
Remain still and do not move until
the measurement is complete.
Read "How to Take a Measurement"
on page 14.
Slightly moisten the soles of your
feet with a damp towel and retake
the measurement.
Refer to the Conditions and Actions
Table on Page 14.
Check the settings entered for your
personal data. Change the settings
if needed. Retake the measurement.
If this error occurs again and the
settings are correct, measurements
cannot be taken.
Remove the batteries. Wait one minute.
Reinstall the batteries. Refer to Battery
Installation on page 9.
Press the power switch and turn the
monitor on. Retake the measurement.
Wait until 0.0 lb is displayed before
stepping onto the
measurement platform.
Do not move the unit until 0.0 lb
is displayed.
Do not move until measurement
.
is complete.
This unit can only be used by
people weighing less than 330 lb.
16
CORRECTION