Settings - Omron GO SMART HJ-203 Instruction Manual

SeTTINGS

3. Setting the minute.
Press
desired value for a setting
Press
• Press ( ) to advance (go back) one
• Press and hold
in increments of 10
. Setting the weight.
Press
desired value for a setting
Press
• Press ( ) to advance (go back) one
• Press and hold
in increments of 10
. Setting the height.
Press
desired value for a setting
Press
• Press ( ) to advance (go back) one
• Press and hold
in increments of 4
or to select the
to confirm the setting.
( ) to advance or go back
or to select the
to confirm the setting.
( ) to advance or go back
or to select the
to confirm the setting.
( ) to advance or go back

SeTTINGS
. Setting the stride length.
The initial stride length value that blinks on the display
is an estimated stride length calculated from your
height setting
Press
desired value for a setting
Press
• Press ( ) to advance (go back) one
• Press and hold
in increments of 4
NOTe:
To get a more accurate stride length, walk about 10
steps, then measure the length for one step (from the
tip of one foot to the tip of the other) Refer to "Stride
length measurement" on page 9.
All the settings are completed.
Adjust the Settings
 Press the SeT button on the
back of the unit with a thin,
sturdy, stick that will not
break easily.
The hour flashes on the display.
2 Follow the procedure from
step 2 on page  "Settings".
NOTeS:
• This does not delete measurement values stored on
the unit, including any stored today
• If no settings are made for more than 5 minutes, the
display will revert to the current step count display
or to select the
to confirm the setting.
( ) to advance or go back