Power Off/On - Kenwood DDX6034 Service Manual

as "Check NG" is displayed.
• The following items shall be checked.
Application Processor Version
System μ-com Version and ROM correction number
Garmin Navi Board Version
M-Star Version
BT Module Version
DVS8000 F/E Version
Region Code
• After performing the Version Check, execute Reset or

Power OFF/ON.

2.4.15. Region / Serial No. writing-in (Production
process)
• In the production process, Region and Serial No. are
written in for every one product using the writing-in jigs.
In this process, the writing-in jigs are connected with the
products through the TV I/F connector.
2.4.17. Procedure to clear Security Code
If the unit is started with the Security ON condition, use the
following procedure to clear the Security Code (in the mode
other than the Test Mode).
DDX6034/6034M/6054/7034BT/7034BTM/714
DNX7000EX/7140/7240BT/7340BT
TEST MODE
1) When the unit is Reset or is powered on after the backup
OFF under the Security ON condition, the unit boots up
from the Security Code Entry screen.
2) Select Audio SW mode on the remote controller, and
manually enter the code following the next procedure:
Step 1: Press Tenkey5 twice
Step 2: Press Tenkey2 three times
Step 3: Press Tenkey2 once
Step 4: Press Tenkey7 twice
When the entry is made improperly during the Steps 1~4,
repeat the code entry from the Step 1 after entering other
remote controller Key.
When the Security Code Entry screen is cleared, the Secu-
rity Code clear is completed.
2.4.18. Other
Do not operate the Back Up Memory function during the
Test mode.
25