Screen Adjustment; Panel Mechanism - Kenwood DDX6034 Service Manual

DDX6034/6034M/6054/7034BT/7034BTM/714
DNX7000EX/7140/7240BT/7340BT
2.4.10. AV IF
• The settings in the Test mode are described in Table 2.4.8.
(The settings of items which are not listed in the table are
as usual.)
AV-IN Interruption
R-CAM Interruption
NAV Interruption SP Setting
• An interruption occurs in R-CAM detection while in nor-
mal detection operation.
• V-IN (R-CAM) mirror mode shall be switched with Tenkey
#3 on the remote controller.

2.4.11. Screen adjustment

• Except for Bright during Illumi OFF, the default shall be
Center. (Default of Bright during Illumi OFF is MAX.)
• One click operation will perform changes in the following
order: MIN ↔ Center ↔ MAX.
• Transfer to the Screen adjustment screen with Tenkey6
on the remote controller.
2.4.12. DC Offset
• DC Offset detection status (normal/error) clear
By pressing the [DC Offset Clear] key in the Service
screen, clear DC Offset detection information.
• DC Offset detection information is displayed on the Infor-
mation screen/Service screen.
• In the Test mode, even if DC Offset is detected, it is not
written into the nonvolatile memory.
However, the detection operation shall be carried out
and when the DC Offset is detected, the Protect shall be
displayed and it becomes all CH Mute operation.
• Volume setting can be changed to the following settings
by pressing Tenkey 2 on the remote controller.
Source : DVD
Assigned DISC : KTD-02A
Assigned Track : 15 (20Hz, 0dB)
Assigned VOL : 26 Step

2.4.13. Panel Mechanism

The Touch operation is operative even in the Full Open state
of the Tilt mechanism.
24
TEST MODE
2.4.14. Clear the contents in the nonvolatile
• Clear the contents in the nonvolatile memory which must
not remain at the time of shipment.
Settings Clear the contents in the nonvolatile memory with the
[SRC] key, the [AUD] key, and the [Reset] key.
ON
ON
Front ALL
• The following information is cleared:
DC Offset information / Memory function/ Retailer mode
information / Service information
• If a jig is connected and the region is written in, the fol-
lowing information shall be cleared.
Serial No. / Security code / Touch correction / LCD ad-
justment value / Mechanism position adjustment value
DC Offset informatio / Memory function / Retailer mode
information / Service information / Illumi adjustment
Notes:
When replacing the following elements by the service staff
members, perform adjustment again in the Test mode since
the following data is cleared.
When replacing E2PROM (X15: IC203),
Security code / Touch correction Mechanism position
adjustment value
DC Offset information / Memory function / Retailer mode
information / Service information
When replacing Flash Memory (X35: IC200) for M-Star,
General LCD adjustment (including the flicker adjust-
ment) Illumi adjustment
When replacing F-RAM (X15: IC800) for Magnum,
Input serial No.
2.4.14. Version Check
• While in the Test mode, connecting a USB containing a
specifi c fi le will compare it with information described in
each version and fi le to judge whether it is O.K. or N.G.
memory (E2PROM etc.)
Clear OK : Change the key illumi to blue.
Clear NG : Change the key illumi to red.
In clearing operation : Change the key illumi to white.
Select black for the background color until "Check OK/
NG" is displayed.
Modify the background color to blue at the same time
as "Check OK" is displayed.
Modify the background color to red at the same time