FINS Commands Addressed to EtherNet/IP Units or Built-in EtherNet/IP Ports
Address Information
Returns the FINS node addresses and IP addresses. Each pair requires 6 bytes and has the following configu-
ration.
1
00
FINS node
IP address
number
FINS Node Address
Node address set in the EtherNet/IP Unit or built-in EtherNet/IP port (hexadecimal).
IP Address
IP address set in the EtherNet/IP Unit or built-in EtherNet/IP port (hexadecimal).
Response Codes
Response code
0000
Normal end
1001
Command too large
IP ADDRESS READ
Reads the local IP address and subnet mask in the CPU Bus Unit System Setup and the FINS node address.
The values read with this command, however, are not necessarily the settings actually used for operation. The
settings that are actually used for operation can be confirmed using CONTROLLER DATA READ (page 392)
and ADDRESS INFORMATION READ (page 414).
This command is supported for CJ-series EtherNet/IP Units only.
Command Block
27 67
Command
code
Response Block
27 67
Command
Response
Number of
code
code
addresses
Parameters
Number of Addresses (Response)
The number of sets of FINS node addresses, IP addresses, and subnet masks being returned. The EtherNet/
IP Unit or built-in EtherNet/IP port is always 0001 (1 decimal).
FINS Node Address (Response)
Node address set on the EtherNet/IP Unit or built-in EtherNet/IP port (hexadecimal).
6 bytes
Description
00
IP address
FINS
node number
Subnet mask
Appendix E
415