Configuring The Host Access List - Xerox WorkCentre 6027 User Manual

Configuring the Host Access List

The host access list controls access to the printer over LPR or Port 9100. You can enter up to five IP
address/mask combinations, and then select to reject, accept, or turn off the filtering for each IP address.
You can enter a specific IP address and address mask, or you can enter a range of IP addresses and
address masks. If no IP address and address mask is entered in the host access list, there are no
limitations on printer access.
You can allow printing from one specific IP address only. The access list would look like the following
table:
Access List IP Address
1 192.168.200.10
You can reject one specific IP address, but allow printing from any other address. The access list would
look like the following table:
Access List IP Address
1 192.168.200.10
2 0.0.0.0
The first row of the access list is the highest priority. If configuring a list with multiple rows, enter the
smallest range first. Make the first row the most specific, and the last row the most general.
For example, you can set up the host access list to do the following:
• Accept printing from a specific network.
• Reject printing from a particular network mask within that network.
• Accept printing from one particular IP address within that network mask.
In this example, the access list would look like the following table:
Access List IP Address
1 192.168.200.10
2 192.168.200.0
3 192.168.0.0
Address Mask
255.255.255.255
Address Mask
255.255.255.255
0.0.0.0
Address Mask
255.255.255.255
255.255.255.0
255.255.0.0
®
Xerox WorkCentre
Installation and Setup
Operation
Accept
Operation
Reject
Accept
Operation
Accept
Reject
Accept
®
6027 Multifunction Printer
User Guide
71