* 2 : For short voltage supply during MENU OFF, executes ONEAF and for
more than 2 second
* 3 : For more than 2 second long voltage supply, moves to the PRESET
0(HOME) position.
7. 5V OUT
Power supply jack for RS-485 JIG. Use within typical DC +5V 100mA.
8. DAY/NIGHT IN
This is a function to receive the external DAY/NIGHT signal from the
sensor(option) and convert the signal into BW.
9. RS-485 DATA-
Jack for connection to RS-485 DATA- signal line.
10. RS-485 DATA+
Jack for connection to RS-485 DATA+ signal line.
seTUp switch
This switch is used to set the function or property. When this switch is pressed
for at least 2 seconds, the MAIN MENU appears.
(left/Right) : By pressing this switch left or right, you can move left or right
(Up/down) : By pressing this switch up or down, you can move up or down on
: When you press this switch in the menu, the selected function is confirmed.
To enter a submenu, press this button.
video OUT port
This is connected to the Video Input Port of the monitor and it outputs the
Video signals.
GNd
This is a grounding port.
power Connection port
This is connected to the Power cable.
power display led
When the power is normally connected, the red LED lights.
10_ installation & connection
on the menu or change the displayed value.
the menu.