Removing A Fuse; Installing The Fuse; Ignition Curve Plug Connection; Changing The Ignition Curve - KTM 450 SMR Owner's Manual

MAINTENANCE WORK ON CHASSIS AND ENGINE

Removing a fuse

9.77

Installing the fuse

9.78
Warning
Fire hazard The electrical system can be overloaded by the use of incorrect fuses.
–
Use only fuses with the prescribed amperage. Never by-pass or repair fuses.

Ignition curve plug connection

9.79

Changing the ignition curve

9.80
Changing the ignition curve from Performance to Soft.
–
Separate plug connection
Soft – better driveability
Changing the ignition curve from Soft to Performance.
–
Connect plug connection
Performance – higher performance
–
Switch off all power-consuming components and switch off the engine.
–
Dismount the air filter box lid. (
–
Remove the protection cover
Info
The fuse
–
Remove the fuse
400270-10
–
Insert the fuse.
Fuse (58011109110)
Info
A reserve fuse
Replace a burned-out fuse
If the new fuse burns out, contact an authorized KTM workshop.
–
Replace the protection cover.
400273-10
–
Install the air filter box lid. (
The plug connection
Possible states
Soft – If the plug connection is separated, riding is more flexible.
•
Performance – If the plug connection is connected, higher performance is
•
achieved.
500218-10
. (Figure 500218-10 p. 52)

. (Figure 500218-10 p. 52)

p. 58)
.

is located in the starter relay

.

is located in the starter relay.

only by an equivalent fuse.

p. 58)
is located in front of the fuel tank on the left of the frame.

under the filter box cover.

52