Table of Contents
Advertisement
Removing the Master I/O Board
1.
Follow the instructions in "Before You Begin" on page
2.
Remove the left side-panel (see "Removing the Left Side-Panel" on page
3.
Open the PCI shroud (see "Opening the PCI Shroud" on page
4.
Remove the drive-bay shroud (see "Removing the Drive-Bay Shroud" on
page 19).
5.
Remove the PCI-fan assembly (see "Removing the PCI-Fan Assembly" on
page 44).
6.
Disconnect all cables from the connectors on the master I/O board. Note
the routing of all cables as you remove them so that you can re-route them
correctly after installing the new master I/O board.
7.
Remove the four screws that secure the master I/O board to the chassis.
8.
Remove the master I/O board out of the chassis.
6.
11).
18).
1 screws (4)
CHAPTER 14: MASTER I/O BOARD
1
072
/
072
Advertisement
Table of Contents
