Removing The Hard-Drive Fan Assembly - Alienware AURORA D0IM Service Manual

Removing the Hard-Drive Fan Assembly

1. Follow the instructions in "Before You Begin" on page
2. Remove the left side-panel (see "Removing the Left Side-Panel" on page
3. Open the PCI shroud (see "Opening the PCI Shroud" on page
4. Remove the drive-bay shroud (see "Removing the Drive-Bay Shroud" on
page 19).
5. Disconnect the hard-drive fan assembly cable from the connector on the
master I/O board. Make note of the cable routing before disconnecting the
cable.
6. Lift the hard-drive fan assembly out of the chassis.
6.
11).
18).
1 hard-drive fan assembly cable
CHAPTER 8: FANS
1
2
2 hard-drive fan assembly
042
/
042