Table of Contents
Advertisement
This Connector are 6 phone Jack for LINE-OUT, LINE-IN, MIC, Surrback, Surround,
CEN/LEF
Line-in :
(BLUE)
Line-out :
(GREEN)
MIC :
(PINK)
Surrback :
CEN/LEF :
Surround: (GRAY)
(7) Floppy drive Connector (34-pin block): FDD1
This connector supports the provided floppy drive
ribbon cable. After connecting the single plug end to
motherboard, connect the two plugs at other end to
the floppy drives.
(8) Secondary IDE Connector (40-pin block): IDE1
This connector connects to the next set of Master and Slave hard
disks. Follow the same procedure described for the primary IDE
connector. You may also configure two hard disks to be both
Masters using one ribbon cable on the primary IDE connector and
another ribbon cable on the secondary IDE connector.
• Two hard disks can be connected to each connector. The first
HDD is referred to as the "Master" and the second HDD is referred to as the "Slave".
• For performance issues, we strongly suggest you don't install a CD-ROM or DVD-ROM
drive on the same IDE channel as a hard disk. Otherwise, the system performance on this
channel may drop.
(9) Serial-ATA Port connector:
SATA1 / SATA2
Audio input to sound chip
Audio output to speaker
Microphone Connector
(ORANGE)
Audio output to speaker-Rear speaker out
(BLACKNESS) Audio output to speaker-Center/Subwoofer speaker out
Audio output to speaker-Side speaker out
PS/2
Mouse
PS/2
Keyboard
PRINTER
VGA
COM1
SATA2
SATA1
Serial-ATA1 & 2 Compatible Connectors
10
Optional 10/100Mbps LAN
USB1
UL2
FDD
Pin 1
Floppy Drive Connector
IDE1
IDE1
Pin 1
Primary IDE Connector
Line-IN
Surrback
Line-OUT
CEN/LFE
Surround
MIC-IN
Advertisement
Table of Contents
