Table of Contents
Advertisement
Hardware Installation
2-1 Install Socket AM2 Supported AMD Processor
This motherboard provides a 940-pin surface mount, Zero Insertion Force (ZIF) socket,
referred to as the mPGA940 socket supports AMD Athlon64 processor in the 940 Pin package
utilizes Flip-Chip Pin Grid Array package technology.
The CPU that comes with the motherboard should have a cooling FAN attached to prevent
overheating. If this is not the case, then purchase a correct cooling FAN before you turn on
your system.
WARNING!
Be sure that there is sufficient air circulation across the processor's
heatsink and CPU cooling FAN is working correctly, otherwise it may
cause the processor and motherboard overheat and damage, you may install
an auxiliary cooling FAN, if necessary.
To install a CPU, first turn off your system and remove its cover. Locate the ZIF socket and
open it by first pulling the level sideways away from the socket then upward to a 90-degree
angle. Insert the CPU with the correct orientation as shown below. The notched corner
should point toward the end of the level. Because the CPU has a corner pin for two of the
four corners, the CPU will only fit in the orientation as shown.
When you put the CPU into the ZIF socket. No force require to insert of the CPU, then
press the level to Locate position slightly without any extra force.
2-2
Install Memory
The motherboards provide
(DIMM) sites for DDRII memory expansion available from minimum memory size of
128MB to maximum memory size of 8.0GB / 4.0GB DDRII SDRAM.
Valid Memory Configurations of 2-DIMM Design Motherboard
Bank
Bank 0, 1 (DIMM1) DDRII400/DDRII533/DDRII667/DDRII800
Bank 2, 3 (DIMM2) DDRII400/DDRII533/DDRII667/DDRII800
Total
Chapter 2
Colden Arrow
four / two
240-pin DDRII DUAL INLINE MEMORY MODULES
240-Pin DIMM
System Memory (Max. 4.0GB)
CPU ZIF mPGAB Socket
6
PCS
Total Memory
X1
128MB∼2.0GB
X1
128MB∼2.0GB
2
128MB∼4.0GB
Advertisement
Table of Contents
