Kyocera DP-750 Service Manual page 82

3LL/3LK
8. Remove the original feed belt shaft B from the
original feed belt unit.
9. Remove the original feed collar B and DP
original feed belt from original feed belt shaft
B.
10. Remove two stop rings from the forwarding
pulley shaft.
11. Remove each two pulleys and pins.
12. Pull out the forwarding pulley shaft from the
original feed unit and then remove the DP
forwarding pulley.
13. Check or replace the DP original feed belt
and DP forwarding pulley and refit all the
removed parts.
1-5-4
Original feed belt unit
Pulley
Bush
Pin
Pin
Forwarding
pulley shaft
Original feed unit
Original feed belt shaft B
Original feed collar B
DP original feed belt
Figure 1-5-5
DP forwarding pulley
Stop ring
Stop ring
Figure 1-5-6
Bush
Pulley