Kyocera DP-750 Service Manual page 42

3LL/3LK
Maintenance
item No.
Setting of deflection for feeding from DP
U942
Description
Adjusts the deflection generated when the DP is used.
Purpose
Use this mode if an original non-feed jam, oblique feed or wrinkling of original occurs when the DP is used.
Setting
1. Press the start key.
2. Select the item to be adjusted.
Display
REGIST TOP
REGIST BACK
REGIST MIX
3. Press the system menu key.
4. Place an original on the DP and press the start key to make a test copy.
5. Press the system menu key.
6. Change the setting value using the +/- or numeric keys.
The greater the value, the larger the deflection; the smaller the value, the smaller the deflection.
If an original non-feed jam or oblique feed occurs, increase the setting value. If wrinkling of original
occurs, decrease the value.
7. Press the start key. The setting is set.
Completion
Press the stop key. The screen for selecting a maintenance item No. is displayed.
Checking/clearing the time for the exposure lamp to light
U990
Description
Displays, clears or changes the accumulated time for the CIS to light.
Purpose
To check duration of use of the CIS. Also to clear the accumulated time for the CIS after replacement.
Method
1. Press the start key.
The accumulated time of illumination for the CIS is displayed in minutes.
2. Clear the accumulated time using the +/- or numeric keys.
3. Press the start key. The time is set.
Completion
Press the stop key. The screen for selecting a maintenance item No. is displayed.
1-3-22
Description
Description
Deflection of single-sided original
Deflection of double-sided original
Deflection of dual scanning
Setting Initial Change in
-31 to 31 0 0.176 mm
-31 to 31 0 0.176 mm
-31 to 31 0 0.176 mm