Mechanical Problems - Kyocera DP-750 Service Manual

1-4-4

Mechanical problems

Problem
(1)
No primary original feed.
(2)
No secondary original
feed.
(3)
Originals jam.
Causes/check procedures
The surfaces of the DP original feed belt, DP
forwarding pulley or DP separation pulley are
dirty with paper powder.
Check if the DP original feed belt, DP forward-
ing pulley or DP separation pulley is
deformed.
The registration pulley and the registration
roller do not contact each other correctly.
Originals outside the specifications are used.
The surfaces of the DP original feed belt, DP
forwarding pulley or DP separation pulley are
dirty with paper powder.
The eject pulley and the eject roller do not
contact each other correctly.
Corrective measures
Check and clean them with isopropyl alcohol
if they are dirty.
If so, replace (see page 1-5-2, 5).
Check and clean them with isopropyl alcohol
if they are dirty.
Use only originals conforming to the specifi-
cations.
Check and clean them with isopropyl alcohol
if they are dirty.
Check visually and remedy if necessary.
3LL/3LK
1-4-11