Display Assembly - HP Pavilion Maintenance And Service Manual

Display assembly

IMPORTANT:
and replacement.
Before removing the display assembly, follow these steps:
1. Shut down the computer.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the base enclosure (see
components:
a. Battery (see
b. Optical drive (see
c. Hard drive (see
d. Solid-state drive (see
e. Memory (see
f. WLAN module (see
g. Fan (see
h. Heat sink (see
i. Speakers (see
j. System board (see
k. WLAN antenna (see
Remove the display assembly:
1. Disconnect the WLAN antenna cable (1) and the display cable (2).
Make special note of each screw and screw lock size and location during removal
Base enclosure on page
Battery on page
Optical drive (select products only) on page
Hard drive on page
SSD (M.2) on page
Memory on page
WLAN module on page
Fan on page 41).
Heat sink on page
Speakers on page
System board on page
WLAN antenna on page
28), and then remove the following
30).
31).
33).
34).
37).
43).
53).
48).
65).
26).
Component replacement procedures 39