Pressure Monitor - Mercedes-Benz 2016 GL Operator's Manual

too low and must be corrected at the next
opportunity.
If the Check Tires
R
multifunction display, the tire pressure in
one or more tires has dropped significantly
and the tires must be checked.
If the Warning Tire Malfunction
R
sage appears in the multifunction display,
the tire pressure in one or more tires has
dropped suddenly and the tires must be
checked.
i
If the wheel positions on the vehicle are
rotated, the tire pressures may be dis-
played for the wrong positions for a short
time. This is rectified after a few minutes of
driving, and the tire pressures are displayed
for the correct positions.
Restarting the tire pressure monitor
When you restart the tire pressure monitor, all
existing warning messages are deleted and
the warning lamps go out. The monitor uses
the currently set tire pressures as the refer-
ence values for monitoring. In most cases, the
tire pressure monitor will automatically
detect the new reference values after you
have changed the tire pressure. However, you
can also define reference values manually as
described here. The tire pressure monitor
then monitors the new tire pressure values.
Set the tire pressure to the value recom-
X
mended for the corresponding driving sit-
uation on the Tire and Loading Information
placard on the driver's side
B-pillar ( page 408).
Y
Additional tire pressure values for different
loads can also be found on the tire pressure
table on the inside of the fuel filler flap
( page 408).
Y
Make sure that the tire pressure is correct
X
on all four wheels.
Make sure that the SmartKey is in position
X
2 in the ignition lock.
Press the = or ; button on the steer-
X
ing wheel to select the
message appears in the
mes-
Service menu.
Press the 9 or : button to select
X
Tire Pressure.
Press the a button.
X
The multifunction display shows the cur-
rent tire pressure for the individual tires or
the Tire pressure will be displayed
after driving a few minutes
sage.
Press the : button.
X
The Use Current Pressures as New
Reference Values
the multifunction display.
If you wish to confirm the restart:
Press the a button.
X
The Tire Pressure Monitor Restarted
message appears in the multifunction dis-
play.
After driving for a few minutes, the system
checks whether the current tire pressures
are within the specified range. The new tire
pressures are then accepted as reference
values and monitored.
If you wish to cancel the restart:
Press the % button.
X
The tire pressure values stored at the last
restart will continue to be monitored.
Radio type approval for the tire pres-
sure monitor
Country Radio type approval number
USA FCC ID: MRXMW2433A
FCC ID: MRXGG4
FCC ID: MRXMC34MA4
Canada IC: 2546A-MW2433A
IC: 2546A-GG4
IC: 2546A-MC34MA4
Tire pressure
mes-
message appears in
Z
415