Resetting - Mercedes-Benz 2016 GL Operator's Manual

Side windows
100
Proceed as follows if someone is trapped:
Release the & button to interrupt the
R
closing procedure.
Press and hold the % button to open.
R
Vehicles with KEYLESS-GO:
Release the sensor surfaces on the exterior
R
door handle to interrupt the closing proce-
dure.
To open, pull the same door handle imme-
R
diately and hold it firmly. The door windows
and the sliding sunroof will open for as long
as the door handle is held but the door is
not opened.
i
Notes on the automatic reversing feature
for:
the side window (
R
the sliding sunroof (
R
Using the SmartKey
The SmartKey must be close to the vehicle.
For vehicles without KEYLESS-GO, the Smart-
Key must be near the driver's door handle.
Vehicles without KEYLESS-GO: point the
X
tip of the SmartKey at the door handle on
the driver's door.
Press and hold the & button until the
X
side windows and the sliding sunroof or the
panorama roof with power tilt/sliding
panel are fully closed.
Make sure that all the side windows and the
X
sliding sunroof or panorama roof with
power tilt/sliding panel are closed.
On vehicles with a panorama roof with power
tilt/sliding panel:
Press and hold the & button again until
X
the roller sunblinds of the panorama roof
with power tilt/sliding panel close.
To interrupt convenience closing:
X
release the & button.
page 98)
Y
page 103)
Y
Using KEYLESS-GO
Touch recessed sensor surface : on the
X
door handle until the side windows and the
sliding sunroof or the panorama roof with
power tilt/sliding panel are fully closed.
i
Make sure you only touch recessed sen-
sor surface :.
Make sure that all the side windows and the
X
sliding sunroof or panorama roof with
power tilt/sliding panel are closed.
Vehicles with a panorama roof with
X
power tilt/sliding panel: touch recessed
sensor surface : on the door handle again
until the roller sunblinds of the panorama
roof with power tilt/sliding panel close.
To interrupt convenience closing:
X
release recessed sensor surface : on the
door handle.
Resetting the side windows
If a side window can no longer be closed fully,
you must reset it.
Close all the doors.
X
Turn the SmartKey to position 1 or 2 in the
X
ignition lock.
Pull the corresponding switch on the door
X
control panel until the side window is com-
pletely closed ( page 98).
Y
Hold the switch for an additional second.
X