Blind - Mercedes-Benz 2016 GL Operator's Manual

again automatically. However, the automatic
reversing feature is only an aid and does not
relieve you of the responsibility of paying
attention when closing the roller sunblinds.
G WARNING
The reversing feature does not react in par-
ticular to soft, light and thin objects, e.g. small
fingers. This means that the reversing feature
cannot prevent someone being trapped in
these situations. There is a risk of injury.
When closing the roller sunblind, make sure
that no body parts are in the sweep area.
If somebody becomes trapped:
release the switch immediately, or
R
press the switch in any direction during the
R
automatic closing process
The closing process is stopped.
Opening and closing the roller sun-
blinds
Overhead control panel
To open
:
To open
;
To close
=
Turn the SmartKey to position 1 or 2 in the
X
ignition lock.
Press or pull the 2 switch in the corre-
X
sponding direction.
i
If you press the 2 switch beyond the
point of resistance, an automatic opening/
closing process is started in the corre-
sponding direction. You can stop automatic
operation by pressing/pulling the switch
again.
Resetting the panorama roof with
power tilt/sliding panel and the roller
sunblinds
! If the panorama roof with power tilt/slid-
ing panel and the roller sunblinds cannot be
fully opened or closed after resetting, con-
tact a qualified specialist workshop.
Reset the panorama roof with power tilt/slid-
ing panel and the roller sunblinds if the pan-
orama roof with power tilt/sliding panel or
the roller sunblinds do not move smoothly.
Turn the SmartKey to position 1 or 2 in the
X
ignition lock.
Pull the 2 switch repeatedly to the point
X
of resistance in the direction of arrow =
until the panorama roof with power tilt/
sliding panel is fully closed.
Keep the 2 switch pulled for an addi-
X
tional second.
Pull the 2 switch repeatedly to the point
X
of resistance in the direction of arrow =
until the roller sunblinds are fully closed.
Keep the 2 switch pulled for an addi-
X
tional second.
Make sure that the panorama roof with
X
power tilt/sliding panel (
the roller sunblinds (
fully opened again.
If this is not the case, repeat the steps
X
above again.
Sliding sunroof
page 104) and
Y
page 105) can be
Y
Z
105