Lubrication - Epson Stylus Photo R340 Service Manual

EPSON Stylus Photo R340/350

4.1.3 Lubrication

The lubrication used for the components of Stylus Photo R340/350 has been decided
on based on evaluation carried out by Epson. As a result, the specified amount of
lubricant should be applied in the places specified when carrying out repair and
maintenance work.
When wiping off the grease during the cleaning
If necessary when performing assembly/disassembly of the printer
Never use oil or grease other than those specified in this
C A U T I O N
manual. Use of different types of oil or grease may damage the
components or affect the printer functions.
Never apply a larger amount of oil or grease than specified in
this manual.
Table 4-1. Oil Applied to Stylus Photo R340/350
Type Name
G-26
Grease G-63
G-74
When using G-74, it is recommended to use a flux dispenser
C A U T I O N
(1049533) together.
Maintenance
EPSON Code Supplier
1080614
1218320 EPSON
1409257
Overview
Refer to the following figures for the lubrication points.
Hopper
Lubrication Point
Hopper
Lubrication Point Lubrication Point
Revision A
<Lubrication Point>
Point on the right side of the
Hopper as shown in the figure
<Lubrication Type>
G-74
<Lubrication Amount>
Adequate dose
<Remarks>
• Use a flux dispenser to apply it
• Be careful not to apply too
much.
<Lubrication Point>
Two points on the Hopper shown
in the left figure.
<Lubrication Type>
G-74
<Lubrication Amount>
Adequate dose
<Remarks>
Use a flux dispenser to apply it
113