Control Panel Components - Vulcan-Hart VC5GD Service Manual

FULL SIZE GAS CONVECTION OVEN - REMOVAL AND REPLACEMENT OF PARTS
Fig. 4
5. Slide right side rear panel up and to the right to
remove.
6. Reverse procedure to install.
Left Side Panel
1. Remove screws along right side, middle left side,
and bottom on left side panel.
2. Loosen screws on top and bottom on left side of
panel.
3. Loosen two screws near front of oven, which
secure bottom front cover.
Fig. 5
4. Lift up and pull away to remove.
5. Reverse procedure to install.
F45598 (0616)
Control Panel
1. Remove three screws on the right side which
secure the control panel then left up and pull
away.
2. Disconnect the temperature probe leads from the
solid state temperature control.
3. Unplug the wire harnesses connector to control
panel components.
4. Unplug Ground wire from control panel.
5. Reverse procedure to install.

CONTROL PANEL COMPONENTS

1. Remove CONTROL PANEL.
2. Remove component being replaced.
3. Reverse procedure to install replacement
component.
4. Check oven for proper operation.
Page 6 of 35
Fig. 6
Disconnect the
electrical power to the machine and
follow lockout / tagout procedures.