Low Cut Filter - DigiTech vocalist live fx Owner's Manual

Low Cut Filter

The Low Cut Filter prohibits excessively low frequencies (below the usual range of
a vocal signal) from passing through the vocal microphone. These excessively low
frequencies generally don't add anything to the vocal's sound and, when removed,
can help with preventing the low end of the mix from becoming "muddy". The cutoff
frequency of the Low Cut Filter is fixed at 75Hz.
Available parameter:
• LO CUT (On/Off )
This parameter turns the Low Cut Filter on and off.
To dial in the Low Cut Filter:
1. Press and hold the <GOLD CHANNEL> button to edit the effect.
2. Press the <DATA> encoder twice to navigate to page 3 in the menu (3/3).
3. In some applications it may be difficult to hear this filter, but in most cases it
will be beneficial to go ahead and enable it. If you do want to audition the effect,
sing into the microphone (or use the Sound Check feature, see
) and turn the Low Cut Filter on.
on page 18
4. Determine if your voice sounds audibly thinner. You can toggle the Low Cut
Filter on and off to further audition the filter. Unless the Low Cut Filter has an
adverse effect on your vocal sound, leave it enabled.
Owner's Manual
Press & Hold To Edit
"Sound Check"
49