An Error Message Is Displayed On The Lcd - Canon PIXMA MP470 series Quick Start Manual

An Error Message Is Displayed on the LCD
If an error message is displayed on the LCD, take the corresponding action described below.
- - 1 - - . - - - - - - - - - - - - -
'---1
The following ink cartridge cannot be The FINE Cartridge may not be compatible with this machine. Install the
recognized. appropriate FINE Cartridge. See "Replacing a FINE Cartridge" on page 46.
U140
The FINE Cartridge may not be installed properly, or the Cartridge may not be
I
compatible with this machine. Open the Scanning Unit (Printer Cover) and
I
install the appropriate FINE Cartridge.
,
" i l f the error is not resolved, the FINE Cartridge may be damaged. Contact your
_________._.____ Canon
~~~e repr~sen~tiv_e_.
.. .. ..... .... __
One or more ink cartridges are not Make sure that each FINE Cartridge is installed in the correct position.
Installed In place. See "Replacing a FINE Cartridge" on page 46.
U075
Some ink cartridges are not installed in
I
place.
U076
The following ink cartridge cannot be
recognized.
U051/U052/U053/U059
The following ink cartridge cannot be
recognized
U150
I
The FINE Cartridge may not be installed properly.
I
Open the Scanning Unit (Pnnter Cover) and Install the FINE Cartndge properly
I
If the error IS not resolved, the FINE Cartndge may be damaged Contact your
I
Canon ServIce representative
The Ink may have run out
RePlacln~k
may have run out - - - - - - . - - -
---l
the Ink tank IS recommended
I
The functIon for detecting the remaining Ink level will be disabled since the Ink
U162 level cannot be correctly detected
If you want to continue pnntlng without thiS function, press the Stop/Reset
button for at least 5 seconds
Canon recommends to use new genuine Canon cartndges In order to obtain
I
optimum qualities.
i
Please be advised that Canon shall not be liable for any malfunction or trouble
caused by continuation of printing under the ink out condition.
I~
Note
1
lf the function for detecting the remaining ink level is disabled, the ink cartridge
in grey is displayed in the remaining ink volume screen on the LCD. See
I
I ...
"Getti~!!.the
Ink Status
Inforrnatio_n~
on
pag~~
...
J
I
The ink has run out. Replace the ink Ink has run out.
I
i
cartndge. Replace the ink cartridge and close the Scanning Unit (Printer Cover).
U163 Ilf printing is in progress and you want to continue printing, press the Stop/Reset
I
button for at least 5 seconds with the ink cartridge installed. Then printing can
I
continue under the ink out condition.
The function for detecting the remaining ink level will be disabled.
Replace the empty ink cartridge immediately after the printing. The resulting
print quality is not satisfactory, if printing is continued under the ink out
condition.
~
Note
If the function for detecting the remaining ink level is disabled, the ink cartridge
I
in grey is displayed in the remaining ink volume screen on the LCD. See
I
.-----------1
"Getting the Ink Status. Information" on page 46:. . __
There is no photo data. _ There are no image data saved on the memory card that can be read by this
machine.
I
-
The machine may not recognize the file if the file name or the folder path
contains certain characters. Use only alphanumeric characters.
I -
Photo data edited or processed on a computer must be printed from the
I
____________________L
c~J'..ut_er_.
. ...__. _
Troubleshooting 57