Troubleshooting; Error Message Is Displayed On The Lcd - Canon PIXMA mini320 Series Manual

Troubleshooting

This section describes troubleshooting tips for problems you may encounter when
using the printer.
Note
This section mainly describes the methods of printer operation for troubleshooting. To
handle problems using your computer, refer to "Troubleshooting" in the User's Guide on-
screen manual. For details on how to view the on-screen manuals, "Reading the On-
screen Manuals" on page 47.
"Error Message Is Displayed on the LCD" on page 35
"LCD Cannot Be Seen At All" on page 38
"An Unintended Language Is Displayed on the LCD" on page 38
"Cannot Install the Printer Driver" on page 39
"Cannot Connect to Computer Properly" on page 40
"Print Results Not Satisfactory" on page 40
"Printer Does Not Start" on page 43
"Paper Does Not Feed Properly" on page 43
"Paper Jam" on page 43
"The Power Lamp (blue) and Alarm Lamp (orange) Flash Alternately" on page 44
"Error Message Appears on a PictBridge Compliant Device" on page 44
"Cannot Remove a Memory Card" on page 46
"Cannot Print Properly through Wireless Communication" on page 46

Error Message Is Displayed on the LCD

Cause
The following ink may If the lamp on the ink tank is flashing, ink may have
have run out. run out.
Replacing the ink tank is
Replacing the ink tank is recommended.
recommended.
If printing is in progress and you want to continue
U041
printing, press the OK button with the ink tank
installed. Then printing can continue. Replacing the
ink tank is recommended after the printing. The
printer may be damaged if printing is continued under
the ink out condition.
See "Replacing an Ink Tank" on page 30.
Action
Cause
The print head lock lever The lock lever of the Print Head is not set properly
is not properly applied. (there are two tabs of the lock lever). Push both tabs
Open the cover and press (left and right) until each clicks into place.
the lock buttons on both
ends of the lever.
The ink tank is not set properly. Push the ink tank until
it clicks into place.
The following ink tank The ink tank is not set properly. Push the ink tank
cannot be recognized. until it clicks into place and ensure that the ink lamp is
U043 lit red.
Print head is not installed. Remove the Print Head and then reinstall it. If the
error is not resolved, the Print Head may be
Install the print head.
damaged. Contact your Canon Service
U051
representative.
The type of print head is
incorrect.
Install the correct print
head.
U052
The following ink tank The ink tank is not compatible with this printer. (The
cannot be recognized. lamp on the ink tank is off.)
U140 Install an appropriate ink tank.
U150 See "Replacing an Ink Tank" on page 30.
An Ink tank error has occurred. (The lamp on the ink
tank is off.) Replace the ink tank.
See "Replacing an Ink Tank" on page 30.
Action
Troubleshooting 35