An Error Message Is Displayed On The Lcd - Canon PIXMA MP450 User Manual

An Error Message Is Displayed On The LCD

If an error message is displayed on the LCD, take the corresponding countermeasure described
below.
Message
There are no photos in memory
card.
There is no paper.
The paper is jammed.
Ink has run out.
U041
The following ink cartridge cannot
be recognized.
U051
U052
U053
U059
Some ink cartridges are not installed
in place.
U075
U076
The waste ink absorber is almost
full.
Incompatible device detected.
Auto head align has failed.
Chapter 11
There are only invalid images on the memory card.
Photo data edited/processed on a computer should be printed from the
computer, not from the camera.
Reload the paper correctly and press [OK].
If paper has jammed in the machine, clear the jam, reload the paper in the
machine correctly and then press [OK].
Replace the FINE Cartridge, and close the Scanning Unit.
If printing is not finished yet, just press [OK] on the machine to continue
printing in the "no ink" state.
Replace the FINE Cartridge with a new one as soon as possible after
printing finishes. The machine may be damaged if printing is continued
under the ink out condition.
The FINE Cartridge may not be installed properly, or the Cartridge may not
be the compatible with this machine. Install the appropriate FINE
Cartridge. If lines are misaligned or the resulting output is not satisfactory,
carry out the FINE Cartridge Alignment.
Confirm that the FINE Cartridges are installed in the appropriate positions.
See "Replacing A FINE Cartridge" on page 76.
Ink used for cleaning is absorbed in a waste ink absorber placed in the
machine.
Press [OK] to cancel the error so that you can continue printing. Once the
waste ink absorber becomes completely full, printing cannot be
performed until the waste ink absorber is replaced.
Canon recommends that you contact a Canon service representative as
soon as possible.
Depending on the model or brand of your device, you may have to select a
print mode compliant with PictBridge before connecting the device.
You may also have to turn ON the device or select Play mode manually
after connecting the device to the machine. Perform the necessary
operations according to the instruction manual supplied with your device.
If the error is still unresolved, there is a possibility that you are using a
digital camera or digital video camcorder that is not supported by this
machine. Use a digital cameras or digital video camcorder compatible with
this machine.
Make sure all required boxes on the head alignment sheet are filled in, and
that the sheet is set in the correct position and orientation on the Platen
Glass.
If the machine is connected to the computer, you can align the FINE
Cartridge using the MP Driver. Follow the procedures described in the
Printer Driver Guide.
Action
Troubleshooting
99