Olympus LS-20M Detailed Instructions page 103

Symptom
Recording level too high
Cannot find the recorded
Voice File
Noise heard during playback
Unable to hear any sound from
the earphone through the
recording monitor
Unable to erase the file
Noise is audible through the
recording monitor
Probable cause
The recording level has not been adjusted.
This could potentially be because the
recording level and output level for
connected external devices are too high.
Wrong folder.
The recorder was shaken during recording.
The recorder was placed near a cell phone
or fluorescent lamp while recording or
during playback.
The settings of the connected external
microphone do not correspond to those of
the recorder.
[Rec Monitor] is set to [Off].
The file is locked.
The file is read-only.
Acoustic feedback is occurring.
Troubleshooting
Action
Adjust the recording level and then try
recording once more (☞ P.35-36, P.68).
If you cannot record clearly even after
adjusting the recording level, then adjust
the output level for the connected devices
(☞ P.35-36, P.68).
Switch to the correct folder
(☞ P.32).
———
Move the recorder.
When a microphone not supported by
the plug-in power function is connected,
turn the [Plug-inPower] setting to [Off]
(☞ P.69).
Set [Rec Monitor] to [On] (☞ P.69).
Unlock the file (☞ P.76).
Unlock the file or cancel the read-only
setting of the file on the PC.
When the built-in speaker amps and the
like are connected there is a risk that audio
feedback will occur while recording. It is
recommended that you use earphones
for the recording monitor, or turn the [Rec
Monitor] to [Off] while recording (☞ P.69).
Perform adjustments, such as further
distancing the earphones from
the microphones, not pointing the
microphones at the earphones, or lowering
the volume of the recording monitor.
6
EN
103