Connect To The Mobile Phone - Skoda Amundsen Owner's Manual

Select ring tone - Select the ring tone if the connected mobile phone does
■
not support the in-band ringing function
Show pictures for contacts - Switch on/off the display of the image assigned
■
to the contact in the telephone

Connect to the mobile phone


Introduction
This chapter contains information on the following subjects:
Conditions for successful pairing
Connect device with your mobile phone
Pairing mobile phone with device
Connection with another paired mobile phone
®
Switch Bluetooth profile on/off
Clear mobile phone from the list of paired devices
Disconnection
First and foremost, pay attention to the safety instructions
tant notes.
The device is displayed in the telephone to be connected to as SKODA BT ...
... is replaced with the last four symbols of the VIN code of your vehicle.
You can change the name of the device
WARNING
The unit may require confirmation of certain features in the mobile phone
when pairing. The pairing process therefore does not take place while driv-
ing - danger of accident!
Note
The maximum number of phones registered is 20. When the maximum num-
■
ber of coupled telephones has been reached, the next one will cause the
paired telephone that has not been used for the longest to be automatically
deleted.
In some countries, the use of phones with the Bluetooth
■
restricted. Further information can be obtained from local authorities.
1) The in-band ringing function makes it possible to use the ring tone of your phone as the ring tone.
2)
This function is only supported by some mobile phones.
36
Phone
1)
2)
» page
» page 19.
®
function may be
The range of the Bluetooth
■
ted to the vehicle interior. This depends on local conditions and on interfer-
ence with other devices.
When pairing from the mobile phone, follow the instructions in the owner's
■
manual of the mobile phone.
Conditions for successful pairing

Read and observe
To connect a mobile phone with the device, the two devices must be paired.
36
Prerequisites for successful pairing:
36
The ignition is switched on.
37 
The Bluetooth
38 
38 The visibility of the mobile phone is switched on

38 The visibility of the mobile phone is switched on.

39
The mobile phone to which the connection is being made must have no

active connection to another mobile phone.
4, Impor-
The pairing can be initiated from the device or from the mobile phone.
Connect device with your mobile phone

Read and observe
A phone is paired with the device
After switching on the unit, the system automatically attempts to connect to
the last connected mobile phone .
While the connection is being created, the message in the device screen may
vary depending on the phone type ... Would you like to connect? And a menu
will appear with the following function keys.
›
Connect - Pairing confirmation
›
Cancel - Cancel the pairing process
If the connection cannot be established the system will attempt to connect to
other previously connected phones one by one.
If there is still no connection, start a phone search.
®
connection to the hands-free system is restric-
on page 36 first.
®
function for the mobile phone
on page 36 first.
» page 19 is switched on.
» page 19.
