Connect The Device With The Mobile Phone - Skoda Infotainment Radio Bolero Owner's Manual
Infotainment radio bolero
Hide thumbs
Also See for Infotainment Radio Bolero:
- Owner's manual (41 pages) ,
- Owner's manual (58 pages)
Table of Contents
Advertisement
Reminder: Remember your mobile - Switch on/off reminder for a connected tel-
■
ephone when the ignition is switched off and the ignition key is removed (or the
ignition is turned off and the driver's door opened in the case of vehicles with
the KESSY system)
Select ring tone - Selects the ring tone if the connected phone does not sup-
■
port the in-band ringing function
1)
Show pictures for contacts - Switch on/off the display of the image assigned to
■
the contact in the mobile phone
2)
Connect the device with the mobile phone
Introduction
This chapter contains information on the following subjects:
Conditions for pairing
®
notes.
The device is shown in the telephone to be connected as SKODA_BT_... .
... is replaced with the last four symbols of the VIN vehicle identification number
of your vehicle.
You can change the name of the device
WARNING
The unit may require confirmation of certain features in the mobile phone
when pairing. Do not carry out the pairing process while driving - there is dan-
ger of accidents!
1)
The in-band ringing function makes it possible to use the ring tone of your phone as the ring tone.
2)
This function is only supported by some phones.
» page
4, Important
» page
20.
Note
The maximum number of phones that can be registered is 20. Upon reaching
■
the maximum number and by pairing a new phone, the least recently used paired
phone will automatically be deleted.
In some countries, the use of the Bluetooth
■
stricted. Further information can be obtained from local authorities.
The range of the Bluetooth
■
depends on local conditions and interference with other devices.
When pairing from the mobile phone, follow the instructions in the owner's
■
manual of the mobile phone.
Conditions for pairing
ings
on page 37.
37
38
To connect a phone with the device, the two devices must be paired.
38
Prerequisites for successful pairing:
39
39
The ignition is switched on.
40
®
The Bluetooth
function of the device
switched on.
40
The visibility of the mobile phone is switched on
The visibility of the mobile phone is switched on.
The mobile phone to be connected should not have an active connection to
another mobile phone.
The pairing can be initiated from the device as well as from the mobile phone.
®
function with phones can be re-
®
connection is restricted to the vehicle interior. This
» page 20
for the mobile phone is
» page
20.
Communication
37
Advertisement
Chapters
Table of Contents
