Table of Contents
Advertisement
4.1.1 Details of Alarm Indications
Table411.doc
No. of
Malfunction contents
times
LED 1
blinks
1
Program ROM Alarm
2
EEPROM Alarm
3
Internal RAM Alarm
4
External RAM Alarm
5
Homing Alarm
6
Spacing Alarm
7
Auto Cutter Alarm
8
Platen Switching Alarm
9
Head A/D Error
10
WDT (F/T Control)
11
NMI (F/W Control)
12
BRK (F/W Control)
13
MICR Unit Error (only
with MICR type)
14
Interface PCB Error (only
OKI standard type)
OP425_04.eps
1
One Cycle
What you should do
Contact the store where you bought the printer or
the Maintenance Service Center
Is the media jammed?
If it is, remove the jammed paper.
Is the ribbon snagged?
Replace the ribbon.
If the above do not apply to your case, contact the
store where you bought the printer or the
Maintenance Service Center
Is a piece of paper jammed in the paper passage of
the Auto Cutter?
Caution: The Auto Cutter blade is very sharp — do
not touch it.
Turn off the printer, then remove the jammed
paper. Be careful not to touch the blade.
If there is no jammed paper, contact your service
department or retailer.
Is the media jammed?
If it is, remove the jammed paper.
If this is not the case, contact the store where you
bought the printer or Maintenance Service Center
Contact the store where you bought the printer or
Maintenance Service Center
Although the MICR Option is not installed in your
printer, is the No. 2 MICR Unit setting in the Menu
"Yes?" (On how to check the Menu Settings, refer
to Section 2.3, "Menu Function."
If it is, change it to "No."
If this is not the case, contact the store where you
bought the printer or Maintenance Service Center
Is I/F board (option) installed correctly?
If not, install it correctly.
Isn't I/F board (option) defective?
If it is, replace the I/F board.
If the above do not apply to your case, contact the
store where you bought the printer or Maintenance
Service Center
Developer's Guide: English
|
59
Advertisement
Table of Contents
