Table of Contents
Advertisement
7.2 About the Validation Printing Area
This section describes the information for the Validation printing area, and it includes notes for using Validation.
1
In Validation mode, you can use the same paper as in Slip mode, but the printing area is not the same as that of Slip mode.
2
Only 1-line printing is supported. When you need to print multiple lines, use the Slip Driver.
3
Use device fonts in the case of Character printing. However, double-high characters are not supported.
4
Test Page Printing at the time of driver installation and Test Page Printing after the installation is done are supported.
5
Double-high device font characters are not supported by Validation.
O425_115.jpg
1
Printing Area
2
Inserting Direction
Symbol
Designation
W
Paper width
A
Print starting position
B
Left margin
C
Right margin
D
Printing area width
|
OKIPOS 425D
132
Standard Value
70 mm (2.7") or more
8 mm (0.7") or less
2.54 mm (0.1") or more
2.54 mm (0.1")
Max 160.02 mm(6.3")
Advertisement
Table of Contents
