Print Mode; Print Suppress - Oki Microline 8480FB User Manual

Print Mode

Choose the print quality and speed: LQ Courier [the default], LQ
Roman, LQ Swiss, LQ Swiss Bold, LQ Orator, LQ Gothic, LQ
Prestige, or Utility.

Print Suppress

The default is No. If your system uses the DC1 and DC3 codes for
print suppress mode, change the setting to Yes.
Prop. Spacing
The default is No. Choose Yes to engage proportional spacing of
characters.
Quiet
The default is Invalid. Choose Valid to reduce printing noise.
Rcv. Buffer
Sets the amount of memory ( 0 or 128 Kbytes) devoted to holding
received data. The default is 128 Kbytes. Changing this to 0 will tie
up your computer while printing, but if you abort the print job, the
printer will stop much sooner.
Regist. Low
Adjusts the print registration for low-speed printing. Available
settings: -5 through +5, in increments of 1/360 inch (0.14 mm).
Regist. Normal
Adjusts the print registration for normal-speed printing. Available
settings: -5 through +5, in increments of 1/360 inch (0.14 mm).
Regist. High 1
Adjust the print registration for high-speed printing. Available
settings: -5 through +5, in increments of 1/360 inch (0.14 mm).
Regist. High 2
Adjust the print registration for draft mode printing. Available
settings: -5 through +5, in increments of 1/360 inch (0.14 mm).
Microline 8480FB User's Guide
• 50